CODEWITHSUNDEEP
c++ioreadlineistream
Jellicle
Jellicle

Reputation: 30276

C++: Did getline() read entire line?

How can I verify that std::istream::getline() reached the delimiter, instead of just max-ing out the input buffer?

I realize that I can use gcount() to determine whether fewer bytes than the buffer holds were read, but what if the line to read is exactly as long as the buffer? Reaching \n would look exactly the same as not reaching \n.

Upvotes: 1

Views: 1105

Answers (2)

Dietmar Kühl
Dietmar Kühl

Reputation: 154025

The conditions for terminating std::istream::getline() are quite precise: If the function stops because n - 1 were stored but no newline was reached, the flag std::ios_base::failbit is set. That is, you can just check the state of the stream to determine if a newline was reached.

That said, unless you need to protect against hostile sources of your data (e.g. an Internet connection send you data until you run out of memory, all on just one line), you should use the std::string version:

std::string line;
std::getline(in, line);

Upvotes: 0

Kerrek SB
Kerrek SB

Reputation: 477514

Don't use member getline at all. The following will always work, using the free function:

#include <string>

std::string line;

if (!std::getline(infile, line)) { /* error */ }

// entire line in "line"

(The answer to your actual question is that you must use member-getline in a loop. But why bother.)

Upvotes: 4

Related Questions