CODEWITHSUNDEEP
esp8266arduino-esp8266
PeeS
PeeS

Reputation: 1164

ESP8266 programming without SDK

There are limitations in the ESP SDK libraries (which are not public) like for example the length of the packet recv (112bytes max) when in promisc mode.

I tried reaching them to get some input and directions - but they seem to be replying nonsense.

Is it possible to program the chip without the SDK - thus make my own SDK and forget their limitations?

Upvotes: 1

Views: 1309

Answers (1)

Solomon Candy
Solomon Candy

Reputation: 93

The processor-core on the esp8266 is an 'xtensa'. The processor-core, or let's just call it the processor, is what we program with C or C++ or assembler. The processor's instruction set is made public by the company (which is Tensilica .. or Cadence??) and once you have the instruction set, you can program directly or make a compiler and have complete freedom with the processor.

The processor-core is not the complete product and for us end-consumers, and companies, like Espressif, buy the Intellectual Property rights to a processor-core's design and build an end-product by putting peripherals like SPI, I2C, UART and in the esp8266's case, the wifi-tranceiver, around the processor-core.

These peripherals are controlled digitally, and output to the processor digitally, so the processor can interface with them - but their action can be either digital or analog. For UART, SPI, I2C etc, espressif has provided us with the datasheet that informs of all the registers that can be used to control that peripheral. It's something like write to this X memory address what you want to transfer and then set the bit Y on the Z memory address to begin the transfer. For SPI for example, there are registers to control speed, polarity, phase etc for a transfer. Once you know how to control a peripheral at the lower level, you can write high level drivers, which espressif does provide too, but you can write your own.

For Wifi, espressif hasn't released how the peripheral can be interfaced with, so we have to depend upon the compiled binaries that espressif sends us. You can use 'objdump -t' on the 'lib/lib80211.a' to get atleast the names of the routines that the Wifi driver provides. You can call these routines from C or assembler code and go a little bit lower than espressif intended but to go any lower would require 'Reverse Engineering' by manually understanding the low level code in the compiled Driver and nobody's gonna take that risk and time-drain.

Upvotes: 5

Related Questions