Is STM32 Cube IDE SystemClock_Config Code right?

Question

`

void SystemClock_Config(void)
{
  LL_FLASH_SetLatency(LL_FLASH_LATENCY_4);
  while(LL_FLASH_GetLatency()!= LL_FLASH_LATENCY_4)
  {
  }
// PWR Clock Enable?

//
  LL_PWR_SetRegulVoltageScaling(LL_PWR_REGU_VOLTAGE_SCALE1);
  while (LL_PWR_IsActiveFlag_VOS() != 0)
  {
  }

  LL_RCC_HSE_Enable();

   /* Wait till HSE is ready */
  while(LL_RCC_HSE_IsReady() != 1)
  {

  }
  LL_RCC_LSI_Enable();

   /* Wait till LSI is ready */
  while(LL_RCC_LSI_IsReady() != 1)
  {

  }
  LL_RCC_PLL_ConfigDomain_SYS(LL_RCC_PLLSOURCE_HSE, LL_RCC_PLLM_DIV_1, 10, LL_RCC_PLLR_DIV_2);
  LL_RCC_PLL_EnableDomain_SYS();
  LL_RCC_PLL_Enable();

   /* Wait till PLL is ready */
  while(LL_RCC_PLL_IsReady() != 1)
  {

  }
  LL_RCC_SetSysClkSource(LL_RCC_SYS_CLKSOURCE_PLL);

   /* Wait till System clock is ready */
  while(LL_RCC_GetSysClkSource() != LL_RCC_SYS_CLKSOURCE_STATUS_PLL)
  {

  }
  LL_RCC_SetAHBPrescaler(LL_RCC_SYSCLK_DIV_1);
  LL_RCC_SetAPB1Prescaler(LL_RCC_APB1_DIV_2);
  LL_RCC_SetAPB2Prescaler(LL_RCC_APB2_DIV_1);
  LL_SetSystemCoreClock(80000000);

   /* Update the time base */
  if (HAL_InitTick (TICK_INT_PRIORITY) != HAL_OK)
  {
    Error_Handler();
  }
}

This code is generated by the STM32 Cube Ide, but I think the code that enables the PWR Clock must be called first. ex(LL_APB1_GRP1_EnableClock(LL_APB1_GRP1_PERIPH_PWR)) If there is really a problem with the code generated by STM32 Cube, I would appreciate it if you could reply to see if my thoughts are correct.