CODEWITHSUNDEEP
hardwareprocessordma
Boolean
Boolean

Reputation: 14664

Direct memory access DMA - how does it work?

I read that if DMA is available, then processor can route long read or write requests of disk blocks to the DMA and concentrate on other work. But, DMA to memory data/control channel is busy during this transfer. What else can processor do during this time?

Upvotes: 17

Views: 19084

Answers (4)

KawaiKx
KawaiKx

Reputation: 9910

During DMA transfer, the CPU is idle and has no control over memory bus. CPU is put in idle state by using high impedance state

Upvotes: 0

Jerry Coffin
Jerry Coffin

Reputation: 490018

First of all, DMA (per se) is almost entirely obsolete. As originally defined, DMA controllers depended on the fact that the bus had separate lines to assert for memory read/write, and I/O read/write. The DMA controller took advantage of that by asserting both a memory read and I/O write (or vice versa) at the same time. The DMA controller then generated successive addresses on the bus, and data was read from memory and written to an output port (or vice versa) each bus cycle.

The PCI bus, however, does not have separate lines for memory read/write and I/O read/write. Instead, it encodes one (and only one) command for any given transaction. Instead of using DMA, PCI normally does bus-mastering transfers. This means instead of a DMA controller that transfers memory between the I/O device and memory, the I/O device itself transfers data directly to or from memory.

As for what else the CPU can do at the time, it all depends. Back when DMA was common, the answer was usually "not much" -- for example, under early versions of Windows, reading or writing a floppy disk (which did use the DMA controller) pretty much locked up the system for the duration.

Nowadays, however, the memory typically has considerably greater bandwidth than the I/O bus, so even while a peripheral is reading or writing memory, there's usually a fair amount of bandwidth left over for the CPU to use. In addition, a modern CPU typically has a fair large cache, so it can often execute some instruction without using main memory at all.

Upvotes: 29

NirmalGeo
NirmalGeo

Reputation: 771

Well the key point to note is that the CPU bus is always partly used by the DMA and the rest of the channel is free to use for any other jobs/process to run. This is the key advantage of DMA over I/O. Hope this answered your question :-)

Upvotes: 3

Tony Delroy
Tony Delroy

Reputation: 106068

But, DMA to memory data/control channel is busy during this transfer.

Being busy doesn't mean you're saturated and unable to do other concurrent transfers. It's true the memory may be a bit less responsive than normal, but CPUs can still do useful work, and there are other things they can do unimpeded: crunch data that's already in their cache, receive hardware interrupts etc.. And it's not just about the quantity of data, but the rate at which it's generated: some devices create data in hard real-time and need it to be consumed promptly otherwise it's overwritten and lost: to handle this without DMA the software may may have to nail itself to a CPU core then spin waiting and reading - avoiding being swapped onto some other task for an entire scheduler time slice - even though most of the time further data's not even ready.

Upvotes: 2

Related Questions